Tilting to the right

1

007659

1. Positive stopper

NOTE:

Returning the blade to the right angle makes the

 

shifting lever return to 0° by itself.

Sighting

 

 

 

1

2

1. Base

 

2. Cutting line

 

 

 

 

 

A

 

 

 

B

 

Turn the positive stopper so that the arrow on it points one of two positions (vertical for 22.5°, horizontal for 45°). Loosen the clamping screws in front and back. Then, tilt the tool base until it stops and secure the base with the clamping screws.

To get 48° bevel angle, move the lever to 48° marking as far as it will go. Turn the positive stopper so that the arrow on it points to the horizontal position. Then, tilt the tool base until it stops and secure the base with the clamping screws.

1

1. Lever

 

 

 

007660

007671

When using the tool without guide rail (accessory) For straight cuts, align the A position on the front of the base with your cutting line. For 45° bevel cuts, align the B position with it.

When using the tool with guide rail (accessory)

For both straight cuts and 45° bevel cuts, always align the A position on the front of the base with your cutting line.

Switch action

1

1.

Lock-off button

2

2.

Switch trigger

 

 

Tilting to the left

1

007661

1.Bevel angle shifting lever

007664

CAUTION:

Before plugging in the tool, always check to see that the switch trigger actuates properly and

returns to the "OFF" position when released.

To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, push in the lock-off button and pull the switch trigger. Release the switch trigger to stop.

The tool can be tilted to the left 1° bevel angle. To get the left 1° bevel angle, loosen the clamping screws in front and back, tilt the tool handle slightly to the right and push two bevel angle shifting levers at the same time in the direction of arrow which has a marking -1. And then tilt the tool handle to the left while pushing these two levers at the same time. Secure the base with the clamping screws.

Speed adjusting dial

1

007663

1.Speed adjusting dial

8

Page 8
Image 8
Makita SP6000 instruction manual Switch action, Speed adjusting dial, Tilting to the right, Tilting to the left