1
007667
1.Adjusting screw for 90 ﾟ
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
1
007668
1.Adjusting screw for 45 ﾟ
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
• | Saw blades |
• | Guide rail |
• | Rip fence (Guide rule) |
• | Miter gauge |
NOTE:
• | Adjusting for accuracy of 22.5° , 48° and |
| cannot be performed. |
• | Clamp |
• | Hex wrench |
• | Sheet set for guide rail |
Replacing carbon brushes
1 |
001145 |
1. Limit mark
• | Rubber sheet set for guide rail |
• | Position sheet set for guide rail |
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
1. Screwdriver
2. Brush holder cap
1
2
007676
12
