FUNCTIONAL DESCRIPTION
CAUTION:
•Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.
Installing or removing battery cartridge
The tool will automatically stop during operation if the tool and/or battery are placed under one of the following conditions:
•Overloaded:
The tool is operated in a manner that causes it to draw an abnormally high current.
1
2
3
014166
CAUTION:
1.Red indicator
2.Button
3.Battery cartridge
In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded. Then pull the switch trigger again to restart.
If the tool does not start, the battery is overheated. In this situation, let the battery cool before pulling the switch trigger again.
•Low battery voltage:
The remaining battery capacity is too low and the tool will not operate. In this situation,
•Always switch off the tool before installing or removing of the battery cartridge.
•Hold the tool and the battery cartridge firmly when installing or removing battery cartridge. Failure to hold the tool and the battery cartridge firmly may cause them to slip off your hands and result in damage to the tool and battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Insert it all the way until it locks in place with a little click. If you can see the red indicator on the upper side of the button, it is not locked completely.
CAUTION:
•Always install the battery cartridge fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you.
•Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not being inserted correctly.
remove and recharge the battery.
Adjusting depth of cut
1. Lever
1
007524
CAUTION:
•After adjusting the depth of cut, always tighten the lever securely.
Loosen the lever on the side of the rear handle and move the base up or down. At the desired depth of cut, secure the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more than one blade tooth projects below workpiece. Using proper cut depth helps to reduce potential for dangerous KICKBACKS which can cause personal injury.
Sighting
Battery protection system
1
2
1.A position
2.Cutting line
3.Base
1 | 1. Star marking |
012128 |
|
3
007525
When cutting, align the A position on the front of the base with your cutting line on the workpiece.
6
