K00375 ADAPTER KIT
Installation Instructions
The K00375 kit is used for installing
1.Note: Bin must be level before installation of ice machine.
A.Remove the foam tape from the front and sides of the bin where the stainless deflector will be located.
B.Remove RH and LH hinge screws and bin door. Remove fillers and old deflector.
C.Place the deflector on the front edge of the bin and align with front bin edge.
D.Place the fillers on the bin, as shown. Make sure the two holes from the stainless deflector and fillers are aligned on the side.
E.Apply foam tape to the front and back of the bin between the fillers. Note: All other required foam tape comes preassembled with the stainless deflector and fillers.
F.Note: It is recommended to RTV intersections and along the inside edge of the foam tape to prevent water
tracking.
2. Refer to ice machine installation manual for ice machine installation procedures.
Filler
Filler | Filler |
|
Double layer of .75”
Wide Foam Tape on
Deflector between Fillers
Screws Typ
Stainless Steel
Deflector
RH and LH Hinge
Screws
Manitowoc Ice, Inc.
2110 South 26th Street, P.O. Box 1720, Manitowoc, WI
Telephone