Q-0600 Compressor Replacement
Installation Instructions
NOTE: THIS REPLACEMENT IS ONLY FOR THE
1.Disconnect power to the ice machine at the electrical disconnect (moving the toggle switch to the off position will not disconnect line voltage).
2.Remove panels (top, front, left and right sides).
3.Recover refrigerant from ice machine.
4.Remove right side corner post (when facing the front of the machine) and back panel.
8.Remove extra section of suction service valve process tube from the ice machine at swedge joint. Repeat this procedure with discharge line. Remove up to T section.
T Section
5.Remove wiring from compressor terminals.
6.Cut tubing (suction, discharge, and process lines) at the compressor ports.
7.Remove compressor from machine. Make sure to crimp and braze shut ports to compressor.
Discharge
Swedge Joint
9. Insert new compressor into the machine as shown.
Suction
Process
Manitowoc Ice, Inc. |
|
2110 South 26 Street, P.O. Box 1720, Manitowoc, WI | 8006173 |
Telephone | Sheet 1 of 3 |
Web Site - www.manitowocice.com | 06/25/01 |
