Manley Labs 50 WATT MONOBLOCK AMPLIFIER owner manual Connecting Your Amplifier

CONNECTING YOUR AMPLIFIER

Setting up your amplifier is rather easy.

1.Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to your preamplifier.

2.Connect the interconnects from the output of the preamplifier or switching center to the RCA input on the top rear of the amplifier.

3.Connect the hot or "+" speaker cable to the red binding post and the common or "-" speaker cable to the black binding post (See diagram 2). Ensure that the other end of the cable is connected correctly to the speaker. Tighten the binding posts by hand. If you use a nut-driver (3/8") do not over-tightenthe posts or you may breaak the connection inside the amplifier.

4.Insure that the "mains" switch on the front panel is in the "off" or "0" position.

5.Turn on Preamplifier and any source components you plan to use.

6.Plug amplifier into wall outlet.

7.Turn on the amplifier and allow it to 'warm up' a minute or so before playing any audio signal.

8.Turn up the volume and enjoy.