SPECIFICATIONS
Frequency Response | 20 Hz to 20 KHz (+/- 1 dB) Mic Pre | |||
| 20 Hz to 50 KHz | |||
THD & Noise | .075% | (1Khz @ +4 dBm) Mic Pre | ||
| .06% | (1Khz @ +4 dBm) Limiter | ||
Signal to Noise ratio | 107 dB |
|
| Limiter |
Headroom | 26 dB (ref +4 dBv) | Limiter | ||
Maximum Output | +30 dBv (75 volts p to p) | Limiter | ||
Maximum Input (with Input at max) | 70 mV mic, | 800mV direct | ||
Maximum Gain (factory set for 45 dB) | 38 dB to 53 dB (internal trimmer) Mic | |||
| 25 dB Direct Instrument 1/4" input | |||
| (knob set to 45 dB)(off to +40 dB range) | |||
| 15 dB |
|
| Limiter |
Maximum Limitting | 20 dB | 11 dB w +4 sine |
| |
Attack Time (fixed) | 20 mS |
|
|
|
Release Time (fixed) | 500 mS |
|
|
|
Input Impedance | 2400 Ohm, transformer coupled | |||
(optimised for mics with 100 to 600 ohm output impedances) | ||||
| 150,000 Ohm @ 1/4" direct input | |||
Output Impedance | 11 Ohms (balanced) |
| ||
| 6 Ohms (unbalanced) |
| ||
XLR | PIN 1 = Ground or Shield |
| ||
(not appropriate for driving unbalanced inputs)PIN 2 = HOT (+) |
|
| ||
| PIN 3 = LOW |
|
| |
1/4" Phone Jack | Sleeve = Ground or Shield |
| ||
| Tip = Signal |
|
| |
(We suggest mono plugs but if a stereo plug must be used the Ring needs to be connected
| to the Sleeve) |
Power Consumption | 20 watts |
Size | 19" X 3.5" X 10" (1U) |
Shipping Weight | 20 lbs |
12
