WARNING 
NEVER CHECK HYDRAULIC FLUID LEVEL WHILE MOTOR IS RUNNING OR
WHILE THE TANK IS STILL WARM AFTER THE MOTOR IS SHUT OFF.
HOT PRESSURIZED FLUID CAN ESCAPE THROUGH THE OPENING
AND CAUSE SERIOUS INJURY.
BEFORE PERFORMING ANY MAINTENANCE, BE SURE THAT:
•LOG SPLITTER IS DISCONNECTED FROM THE POWER SOURCE
•PUSHER PLATE IS FULLY RETRACTED (RETURNED TO THE LOWEST POSITION) AND NO RESIDUAL HYDRAULIC ENERGY IS LEFT IN THE SYSTEM
•OIL HAS COOLED
•Call
•Failure to comply in any way with these instructions, improper use of the log splitter and improper maintenance operations may result in serious injury.
•Manufacturer shall not be liable for any injuries or damage occurred as a result of improper use or improper maintenance of the log splitter.
F.Before You Start Splitting
•Before each use, inspect your unit and ensure that all handles, guards and fasteners are secure and in place. Be sure that all electrical cords are not damaged or broken.
•Before use of the log splitter, check it for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation.
WARNING 
BLOCK WHEELS TO PREVENT SUDDEN MOVEMENT.
•Inspect Hydraulic Fluid Level. Cycle unit a few times and run. Remove the Dipstick using the Allen Wrench provided, clean the Dipstick and insert it to check the oil level. It should be between the two notches on the stem. If level is low, add recommended type of the hydraulic oil. If the level is too high, poor out a little at a time into a suitable container.
•Reinstall the Dipstick and the
Dipstick
Removed
Dipstick
P/N 520112
Adjustable Wrench
Aluminum Top Cover
9
