ENGLISH FRANCAIS ESPANOL PORTUGUES DEUTSCH
ITALINO NEDERLANDS SVENSKA
DANSK
qPOWER switch
Press the button to turn power on (POWER ON mode), and press it again to turn power off (POWER OFF mode). When it is required to remote control the power mode of the MM9000, be sure to leave this switch in the POWER ON mode.
wSTANDBY indicator
This indicator lights up when the unit is put to the STANDBY mode by remote control or based on the video signal input. In the STANDBY mode, the power supply to the internal circuit of the amplifier is cut so the heat generation and power con- sumption are minimized.
ePOWER indicator
The indicator lights up when the power is on and the unit is ready to output sound.
rPEAK indicators
When the output power of a channel is clipped momentary, the corresponding indicator lights in red. If the indicators light continuously in red, decrease the listening volume.
tINPUT LEVEL control
This control sets the amplifier's output level by adjusting its input level.
When you use the MM9000 in a THX system, the knob must be set to THX Ref. (Maximum position)
yAUDIO INPUT jack
Connect the preamplifier output to this jack.
uEXT. CONT IN jack
Not connected when the power is to be controlled from a MA- RANTZ remote control unit.
Connect to the video signal output of a video component when the power is to be controlled based on a video signal.
The external control allows to switch the "POWER ON" and "STANDBY" modes of the unit according to the "presence" and "absence" of video signal.
When the video signal becomes absent while the power of the unit is on, it enters the "STANDBY" mode in about 4 seconds, the unit enters the "POWER ON" mode again when the video signal is input again.
External control using a signal from 5 to 13 V in place of video signal is also possible using this jack. However, as this scheme belongs to the professional use, please consult MARANTZ if you want to adopt such an external control scheme.
iSPEAKER SYSTEM terminals
Connect with speakers using speaker cords. Respect the + and - polarity when connecting speakers.
oAC INLET
Connect AC cord (Supplied) and plug into a household AC power outlet.
!0RC-5 IN / OUT jack
If your system uses a Marantz remote control compatible com- ponent with preamplifier outputs, such as an A/V preamplifier or surround receiver, these jacks allow to turn the power of the MM9000 to ON or OFF/Standby through remote control from the preamplifier or receiver. Before using these jacks, check the owner's manual of the Marantz component to see if it is remote control compatible.
!1Ventilation hole
CAUTION:
When the amplifier is in operation, The temperature of set will rise. Never place any object on the set and back side to maintain ventilation.
!2AC OUTLET
This receptacle supplies AC power regardless of the power switch setting.
The total power consumption of the equipment connected to this receptacle should not exceed 120 W.
2
