Cable Management
Using the cable clampers and beads bands provided with the plasma display; Bundle the signal and audio cables at the back of the unit to connect to the display.
2.Align the batteries according to the 
and 
indication inside the case.
3.Replace the cover.
PD6001 |
Back of the unit |
mounting holes |
To attach
Insert q into a mounting hole, then snap w into the back of q to fix the clamper.
Clampers are designed to be difficult to undo once in place. Please attach carefully. Cables can be routed to the right or left.
Bunch separated cables together and secure them with the provided beads bands.
Do not allow excessive stress to be placed on the ends of cables.
To detach
Using pliers, twist the clamper 90° and pull it outward. In some cases the clamper may have deteriorated over time and may get damaged when removed.
Using the remote control
Battery Installation and Replacement
Designated batteries:
Please use size AAA (R03) or AAA (LR03).
Insert the 2 “AAA” batteries, making sure to set them in with the proper polarity.
1. Press and open the cover.
Operating Range
*Use the remote control within a distance of about 7 m/ 23 ft. from the front of the monitor’s remote control sensor
and at horizontal and vertical angles of up to approximately 30°.
*The remote control operation may not function if the monitor’s remote control sensor is exposed to direct sunlight or strong artificial light, or if there is an obstacle between the sensor and the remote control.
Approx. 7 m/23 ft
CAUTION
•Use only the specified batteries.
•Make sure to insert the batteries correctly according
to the indications of 
and 
.
•Do not drop or mishandle the remote control.
•Do not get the remote control wet. If the remote control gets wet, wipe it dry immediately.
•Avoid heat and humidity.
•When not using the remote control for a long period, remove the batteries.
•Do not use new and old batteries together, or use different types together.
•Do not take apart the batteries, heat them, or throw them into a fire.
9
