The display returns to RAW Mode flashing.
You can:
•Press and release the F.FWD/+ button 
or the
F.REV button 
to tab to another menu choice, or
•Press and release the 
MENU/STORE button to write the menu changes and return to stop mode, or
•Press and release the CANCEL button 
to cancel all menu changes and return to stop mode.
Verify
Verify is an automatic, electronic, Read After Write check. With Verify On, the PMD671 continually reads the CF card about one second after the recording. It compares what is recorded to the source signal. A mismatch results in an error message.
Verify does not depend on the position of the MONITOR switch.
Verify does not function during MP2 record- ing.
See charts on page 14.
How to set or change Verify
Quick instructions |
|
| |
Press & hold | MENU/STORE 2 sec | ....... Preset | |
Double Click ENTER | .................. | RecFormat | |
Press F.FWD/+ | until | ............................ | Verify |
Press ENTER | ..................................... | Off/On | |
Press F.FWD/+ | ........................ toggle Off/On | ||
Press ENTER | ...................................... | Verify | |
Press MENU/STORE .................... | store & exit | ||
|
|
|
|
1.From stop, press and hold the 
MENU/ STORE button for about 2 seconds. Preset will appear (flashing) in the display.
2.While Preset is flashing, double click the EN- TER button 
. Example display
A menu choice will be flashing.
3.Press and release the F.FWD/+
button 
until Verify is displayed.
4.With Verify flash- ing, press and release the ENTER button 
.
Verify menu choice is flashing.
5.Press and re- lease the F.FWD/
+ button 
to
toggle between On and Off.
6.When the desired state is displayed, press and release the
ENTER button
.
The display returns to Verify flashing.
You can:
•Press and release the F.FWD/+ button 
or the
F.REV button 
to tab to another menu choice, or
•Press and release the 
MENU/STORE button to write the menu changes and return to stop mode, or
•Press and release the CANCEL button 
to cancel all menu changes and return to stop mode.
PupPreRec
Power Up Pre Record buffers (remembers) audio during REC PAUSE. When you slide the REC switch to engage record, CONT? is displayed.
•Press and release the PLAY button 
to record the buffered audio and continue recording.
•Slide and release the REC switch again to discard the buffered audio and continue recording from that point.
•Press and release the STOP button 
to discard the buffered audio and stop record- ing.
Note:
If there is less than 5 minutes of REC REMAIN time PupPreRec does not work.
- 35 -