10 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
7. Make four 1-1/2” cuts in one end of the corrugated
tube and fold the flaps back. Cut a 4’ hole through
the floor protection and the floor, and insert the cor-
rugated tube into the hole. Cover it with the supplied
screen and fasten it to the floor protector.
8. Locate the 11-1/2”x 14” metal plate and paint to
match the stove if necessary. Position this piece so
that the 14” dimension evenly overlaps the lips on the
back of the pedestal (see drawing above). Attach this
plate to the back of the pedestal with the self-tapping
screws supplied.
9. If the stove is to be fastened to the floor, attach the
stove with the supplied lag bolts, through the pedestal
base on opposite sides, attaching them into the floor
beneath the floor protection. Seal any irregularities
with silicone sealer.
PeDesTal insTallaTion
(For ash drawer pedestal see instructions included with
pedestal).

Residential and Mobile Homes

(Bolting down and grounding are required only in mobile
homes).

Caution: Wear gloves during installation in case of sharp

edges on the stove.
1. Remove the heater from the carton, if packaged,
upon receipt and check for any damaged or missing
parts.
2. Carefully put the stove on pedestal with the open end
of the pedestal facing the rear. DO NOT LEAVE THE
STOVE UNATTENDED UNTIL IT IS BOLTED SECURELY
TO THE PEDESTAL.
3. Line up the holes in the brackets on the pedestal with
the threaded holes in the bottom of the stove. Use
the two 1/2” long bolts and 3/8” standard washers
to bolt the stove to the pedestal. Be sure to see that
the stove is mounted squarely on the pedestal before
tightening the two bolts securely.
4. When installing a pedestal on this stove you MUST
plug the four leg mounting bolt holes, located on the
bottom of the stove in the four corners, with the bolts
that were used to mount the shipping legs. The two
rear bolts should not be installed more than two full
rotations to prevent lifting the bricks off the bottom of
the stove. FAILURE TO INSTALL THESE FOUR BOLTS
PROPERLY WILL RESULT IN REDUCED CONTROL
OF THE STOVE’S COMBUSTION SYSTEM!
5. If required, install the Outside Air Kit (71112) as per
the following instructions. To locate the hole in the
hearth for outside air mark and cut a 4” hole in the
hearth. The hole’s center should be 3” directly forward
from the center of the flue outlet or locate as per the
instructions below.
6. Position the stove on your floor protection in the
exact location where it is to be located, making sure
all minimum clearances are met. Mark the floor
protection where the pedestal will be located, then
remove the stove.
10. If installed in a mobile home, the heater shall be
grounded to the chassis with a #8 AGW copper wire
or equivalent.
11. Install bricks as per instructions on pages 11 and 12.
It is highly recommended that the baffle be assembled
before the chimney is installed so that the ceramic
fiber blankets can be adjusted into place from the
flue outlet.
12. Install chimney as per manufacturer’s instructions.
Block Off Plate is
Required When
Installing Outside
Air Into Unit (Plate
is Included With
Kit # OAK-P)