Marantz SD4050 manual u w y, Automatic Tape Selection, Playback, English Français

ENGLISH FRANÇAIS

AUTOMATIC TAPE SELECTION

This Stereo Cassette Deck contains an automatic tape selector which automatically selects the optimum bias and equalization for the tape in use. This is accomplished by detection of tape type detection holes in the cassette housing.

PLAYBACK

If a tape without tape type detection holes is used, the deck will be set for normal tapes.

Detection holes

for metal tape Detection holes for chrome tape

The operations described below apply to deck A and deck B alike. Switch on your amplifier or receiver.

Set the Function Selector on your amplifier or receiver to the TAPE or Tape monitor position. The numbers in the illustration below depict the order in which operation steps are carried out.

re

	DOUBLE CASSETTE DECK SD4050
DOLBY NR
C
B
OFF
TIMER
REC
OFF
PLAY
REV. MODE	AUTO REVERSE
AUTO TAPE SELECT/HIGH SPEED DUBBING
CCONT. PLAY
POWER ON/OFF	PLAY A

COUNTER				COUNTER
RESET				RESET
	DUBBING SPEED	REC LEVEL
SYNC REV	NORMAL HIGH		RECORD	PAUSE REC MUTE
STOP	PLAY		STOP	PLAY
EJECT	MIN	MAX	PHONES
				EJECT
		PITCH
		CONTROL –	+

AUTO REVERSE

AUTO TAPE SELECT/HIGH SPEED DUBBING

BREC/PLAY

t q u w y

1.Press the POWER switch q to the ON ( ) position.

2.Press the EJECT ( ) button w to open the cassette compartment cover e.

3.Load the cassette tape and close the cassette compartment cover e.

4.When listening to a tape that has been recorded with Dolby noise reduction, set the DOLBY NR switch r to match the system used at the time of recording.

DOLBY NR

C

B

OFF

5.Select the type of tape transport with the REV MODE switch t.

REV. MODE

6. Press the PLAY button y ( or ) to being playback.

Transport Direction	Indicator
Forward
Reverse

7. Press the STOP ( ) button u to stop the playback.

In the continuous playback mode (REV MODE set to ), playback of both tape sides will be repeated 5 times and then stop automatically.

If different types of Dolby noise reduction are used for record and playback, playback response will be adversely effected. When power is turned off during tape transport, it may not be possible to remove the cassette by pressing the EJECT ( ) button. In this case, turn on power again before you press the EJECT ( )button.

Mode	Switch position
To listen to one side only
To listen to playback of both sides
To listen to continuous play back
of both sides and both decks.

8