Rear and Terminals View

 

Bottom View

IR sensor

Ventilation holes (intake)

Ventilation holes (intake)

 

x

 

 

Ventilation holes

 

 

(exhaust)

 

z

 

 

Lamp cover

Lamp cover

Adjustable

 

securing screw

feet

z

 

 

 

x

Adjustable feet

ENGLISH

zAC IN (☞ P.9)

Connect the supplied AC power code.

xRGB IN

Connect the analog RGB output from an IBM VGA or compatible equipment.

cCOMPONENT VIDEO IN 1 and 2

Terminals 1 and 2 have each Y, PB/CB, PR/CR terminals. Connect them to the component video output of a video device, AV amp/processor, DVD player, etc.

vS-VIDEO IN

Connect the S-VIDEO output from a video equipment.

bVIDEO IN

Connect the composite video output from a video equipment.

nTRIG.1(TRIGGER 1)

When the unit is turned on, 12V is output. When the unit is turned off, no voltage is output. This allows such as a powered up/down screen,whenever the projector is turned on or off.

Note:

•Do not use TRIG.1, as the power source.

•To connect with external devices, use an ordinal 3.5mm mini-plug (mono) cable.

mREMOTE IN/OUT

By connecting this projector to another Marantz audio component using a supplied System Control cable, you can remotely operate the components as a single system.

•When connecting to component with a remote sensor (such as the SR9500,SR8500), be sure to connect the "REMOTE CONTROL IN" jack of this projector to the "REMOTE CONTROL OUT" jack of the component with the remote sensor.

Note:

For connections, use the control adaptor cable. (Mini jack to RCA)

,TRIG.2(TRIGGER 2)

Select ON or OFF at each aspect mode, such as Full, Normal, Zoom, V-Stretch and Through to control screen aspect ratio with powered up/down dual aspect ratio screen.

Notes:

•Do not use TRIG.2, as the power source.

•To connect with external devices, use an ordinal 3.5mm mini-plug (mono) cable.

.HDMI IN 1 and 2

Connect the digital signal (TMDS compliant, single link only)

Note:

To use the HDMI terminal, please follow the cautions on page 10.

⁄0LIGHT ON/OFF

Select ON : The terminal panel lights up.

⁄1RS-232C

This is the control port for the custom installer.

zAdjustment lever (☞ P.12)

Lift the projector and turn the adjustment lever right or left. The adjustable feet will extend from the projector. Then, release the lever, the adjustable feet is locked.

xScrew holes for ceiling mount kit

5