Signal Interpretation
Reading Bottom - In interpreting depth, always read the leading edge (shallowest side) of the signal return. If you have a strong signal return (wide band of RED light) and it starts at 13 feet and ends at 16 feet, the correct depth is 13 feet or the shallowest leading edge of the return signal. Anything beyond the shallow- est leading edge indicates the strength of the return signal.
Reading Fish - Fish will generally appear as separate targets from the bottom. A fish target can be displayed as either RED, ORANGE or YELLOW, depending on the size of the fish and the location within the transmit beam. Larger fish located in the cen- ter of the beam (cone) can appear RED and will be displayed as a wider band on the display. Smaller fish or fish on the outside of the cone may appear ORANGE or even YELLOW. Fish moving through the transmit beam may change color as the return signal strengthens or weakens reflecting their location. Fish that are right on the bottom can appear as part of the bottom. The best indication of a fish sitting right on the bottom is that the leading edge of the bottom return signal is either ORANGE or possibly a dithering or flickering RED segment. It is important that the GAIN or sensitivity be kept to a minimum when displaying a strong bottom return. Too much GAIN will flood out the ability to differentiate targets and clutter the display.
Reading Lures or Bait - The
lure or bait, lower the object to the desired depth and turn up the GAIN until you see the lure or bait on the display. It is important that the GAIN be set so it displays the lure or bait as you raise or lower it. CAUTION: Too much GAIN will cause clutter and may make it difficult to distinguish other targets like fish near the bottom. When tuning the unit to display lures or bait, make sure that the objects are in the center of the hole and therefore in the center of the transmit beam. If there’s water current (some lakes have underwater current or movement) and the lure doesn’t weigh much, it may move to the outer edge of the signal or out of the transmit beam altogether. This will make it difficult or impossible to pick it up on the display.
Dead Zone - All sonar units will have a dead zone in certain circumstances. This occurs on sharp
User Tips
Reading Through Ice - The
Fine Tuning Gain Control - To adjust GAIN properly, lower your lure or bait to within a foot of the bottom. Turn the GAIN up or down until the lure or bait shows as a steady yellow light. You should be able to raise or lower the lure in a jigging fashion without loosing the signal. If the GAIN (or sensitivity) is kept to a minimum, you should be able to separate targets down to 2.15 inches on the
12 | 13 |