Marshall electronic Audiostate LR150, Channel 1 & Channel, Channel 3 & Channel, Master Section

AUDIOSTATE LR150

LR150TopPanelFeatures(page38)

ENGLISH

Channel 1 & Channel 2

1. & 5. Low

Controls the low frequencies on Channel 1 and Channel 2 respectively.

2. & 6. High

Controls the high frequencies on Channel 1 and Channel 2 respectively.

Note - this will be effected by the Effect Return control (item 19) and the Master Reverb control (item 20).

13. & 18. Volume

Controls individual volume level for channel 3 and 4 respectively. Overall volume will be governed by the Master Volume control (item 21).

3. & 7. Effect

When using the in-built reverb on the LR150 this control will adjust the amount of reverb on Channel 1 and Channel 2 respectively. When using an external effects processor this will control the amount of effected signal, as it dictates the amount of signal to the Effects Send (item 10) on the rear panel.

Note - this will be effected by the Effect Return control (item 19) and the Master Reverb control (item 20).

4. & 8.Volume

Controls individual volume level for channel 1 and 2 respectively. Overall volume will be governed by the Master Volume control (item 21).

Channel 3 & Channel 4

9. & 14. Low

Controls the low frequencies on Channel 3 and Channel 4 respectively.

10. & 15. Mid

Controls the mid frequencies on Channel 3 and Channel 4 respectively.

Master Section

19. Effect Return

This is the master Effects Return and is an effects mix control, allowing you to decide when using an external effects processor how much of your overall sound will be effected. Further control is given by the individual Effect control which features on each channel.

20. Master Reverb

The LR150 comes complete with an in-built spring reverb. The overall reverb level for the combo is set here, with independent controls featuring on each channel allowing you to set independent levels for each channel.

21. Master Volume

The overall volume of the combo is set here. As with effects and reverb, there is an independent control on each channel allowing you to set independent volume levels for each channel. This will not however affect the level of the Line Out Jack on the rear panel (item 12).

22. LED

Indicates operating status of combo.

11. & 16. High

Controls the high frequencies on Channel 3 and Channel 4 respectively.

12. & 17. Effect

When using the in-built reverb on the LR150 this control will adjust the amount of reverb on Channel 3 and Channel 4 respectively. When using an external effects processor this control will control the amount of effected signal, as it dictates the amount of signal to the Effects Send (item 10) on the rear panel.

5