Marshall electronic LR230 AUDIOSTATE LR300, LR150RearPanelFeaturespage38, English, Channel

LR150RearPanelFeatures(page38)

ENGLISH

N.B. Reads from right to left on panel. 1. Mains Input

For connection to the mains. We would always recommend that your plug is wired in accordance with your country’s regulations

2. Power

Switches the mains power to the combo

7. Line Input Jack

This is a high impedance unbalanced input.

Channel 4

8. Mic Input XLR

This is a low impedance balanced input for use with microphones.

Channel 1

3. Line Input Jack

This is a high impedance unbalanced input. Typical uses of Line Inputs are Keyboards, drum machines and sequencers.

Channel 2

4. Line Phono Input

This is a high impedance unbalanced input. Typical uses of Line Inputs are drum machines, C.D. players, tape deck, 4 tracks and computers.

5. Line Input Jack

This is a high impedance unbalanced input.

Channel 3

6. Mic Input XLR

This is a low impedance balanced input for use with microphones.

9. Line Input Jack

This is a high impedance unbalanced input.

10. Send Jack

For connection to the input of an external effects processor.

11. Return Jack

For connection to the output of an external effects processor.

12. Line Out Jack

The Line Out jack can be used for connection to recording equipment for direct recording or for connection to a P.A. system. This is not effected by the Master Volume (item 21).

13. Remote Jack

Allows you to switch internal reverb on and off from remote footswitch (optional extra, model no. PEDL-00020).

AUDIOSTATE LR300

LR300TopPanelFeatures(page40)

1, 6, 11, 16 & 23. High

Controls the high frequencies on Channel 1, 2, 3, 4 and 5 respectively.

2, 7, 12, 19, & 24. Effect

When using the in-built reverb on the LR300 this control will adjust the amount of reverb on Channel 1, 2, 3, 4 and 5 respectively. When using an external effects processor this will control the amount of effected signal, as it dictates the amount of signal to the Effects Send on the rear panel.

Note - this will be affected by the Effect Return control (item 28) and the Master Reverb control (item 29).

4, 9, 14, 21 & 26. Vol

Controls individual volume level for Channel 1, 2, 3, 4 and 5 respectively. Overall volume will be governed by the Master Volume (item 30).

5, 10, 15, 22 & 27. Low

Controls the Low frequencies on Channel 1, 2, 3, 4 and 5 respectively.

17. Switch - Speaker Emulator

Switches Speaker Emulator on.

The LR300 features Marshall acclaimed speaker emulation circuitry on Channel 4. When in operation, this will re-voice this channel to suit guitar.

3, 8, 13, 20 & 25. Mid 18. LED

Controls the middle frequencies on Channel 1, 2, 3, 4 and 5 respectively.

Indicates when Speaker Emulator is on.

6