5
Unpacking
Carefully unpack the V-LCD70P-HDA monitor and verify that the following items are included:
• V-LCD70P-HDA Monitor
• V-PS12-5V-XLR Power Supply with 4-Pin Female XLR Connector
• Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should th ere be any damage,
immediately contact Marshall Electronics at (800) 800-6608. If you are not located within the co ntinental United States,
call +1 (310) 333-0606.
Mounting
The V-LCD70P-HDA monitor features a ¼”-20 mounting hole on the underside of the enclos ure, allowing the monitor
to be flexibly mounted to a camera or other device using a variety of mounts.
Changing the Battery Adapter
The V-LCD70P-HDA ships with a single battery adapter, specified at the time of orderin g. Several other batteries
adapters are available to accommodate a variety of batteries.
• Six user-interchangeable “camcorder battery” adapters are available: Canon, Panasonic, JVC, Sony BP ,
Sony NP-Q, and Sony NP-F.
Installation: To uninstall one of the above battery adapters, remove the 5 screws on the adapter . Remove
the adapter and carefully disconnect the 4-pin connector between the monitor and adapter. T o install one
of the above battery adapters, connect the 4-pin connector of the new battery adapter to the m onitor, and
re-install the 5 screws.
Note: Do not change the pinout of the 4-pin connector connecting the battery adapter to the monitor. This
pinout is factory-configured according to each battery adapter.
• IDX and Anton Bauer battery adapters are available, but must be installed at the factory. Contac t Marshall
Electronics for further information.
Connections and Power-On
Plug the V-PS12-5V-XLR power supply into an AC power source (100-240 V @ 50/60 Hz). Att ach the 4-pin female
XLR connector to the back of the monitor. Please note that 12VDC can be also supplied direc tly to the monitor from a
variety of sources. The monitor will draw no more than 1.0 Amps at 12 Volts in operation (12 Watts).
Connect the required cables for video signal input and output. (Power must be applied to th e V-LCD70P-HDA for the
active loop-though outputs to be activated.) All BNC connectors are rated at 75.
The unit defaults to ‘ON’ when power is supplied. Video will automatically be detected and d isplayed on the screen.