Line Level Input Signal Connection (figure 3):
Connect the left and right line level outputs of your pream- plifier to the left and right 'Line Level Input' connections of the Dynamo 300 using quality RCA interconnects. If your preamplifier only has one set of outputs you may need to obtain Y adapters from your dealer.
Speaker Level Input Signal Connection (figure 4):
Connect the left and right outputs of your amplifier to the subwoofer’s left and right 'Speaker Level Input' binding posts. Use quality speaker cable.
If your amplifier only has one set of outputs you may connect your amplifier to your speakers as normal and run an additional set of cables from your speakers to the subwoofer’s 'Speaker Level Input' binding posts.
It is also possible to connect the left and right outputs of your amp to the left and right 'Speaker Level Input' of the subwoofer and run additional cables from your subwoofer to the speakers.
Recommended Control Settings (see figure 2):
1Set the 'Low Pass Filter' knob to approximately 70% of your loudspeakers lowest frequency response.
3While playing music with bass content, turn the 'Level' control up until the music has deep extended bass, being careful to avoid levels that become overwhelming.
4Try the 'Phase' control in different settings until the best blending is obtained.
Multi-Channel/LFE Mode
This setup is recommended if your Dynamo 300 will be used in a dedicated home theater or
If you will be using your system for both
and connection method. Some modern receivers and processors allow users to route left and right channel
Figure 5. Signal connection for
Figure 6. For
Connections and Control Settings 7
