Stand Options 7
NOTE: The Cinema i is intended for use with its stand
attached in almost all installation options. Stand removal
instructions are provided in case you are using a custom
installation that does not require the use of the stand.
Required hardware (included):
(4) #8 x 3/4” Phillips head wood screws, (4) hollow rubber
bumper feet
Required tools (not supplied):
5/32” Allen tool, #2 Phillips head screw driver
WARNING! For safety reasons, when the Cinema i
is used without its stand, it is necessary to install the
rubber bumper feet (included in the instructions
box). The rubber feet help to prevent the Cinema i
from sliding and causing possible injury or dam-
age to the unit. Once the rubber bumper feet are
installed they should not be removed from the
Cinema i even if the mounting stand must be
reinstalled. The mounting stand can attach to the
Cinema i with the rubber bumper feet installed.
1 Prepare a flat surface with padding and sheets to protect
the Cinema i as you work on it. Disconnect any wires
and carefully place the Cinema i upside down on the
work surface, using books or pieces of cardboard to
keep the speaker from rocking.
2 Using the Allen tool remove 6 Allen bolts (3 from each
side) from the Cinema i stand (figure 5, step A).
3 Remove the stand (figure 5, step B).
NOTE: The Cinema i uses 2 types of rubber feet. The feet
refered to in the following step are large and hollow in the
middle so that a screw can pass through.
4 To install the hollow rubber bumper feet, locate the 4
small pilot holes on the bottom of the Cinema i. Insert a
#8 x 3/4” Phillips head wood screw through a rubber
bumper (the wider flat surface should face the speaker
cabinet) and screw the bumper into a pilot hole. Repeat
until all 4 feet are installed. The Cinema i is now ready
for use without the stand (figure 5, step C).
Installing the Stand
NOTE: The Cinema i is intended to be used with its stand
attached in almost all installation options. Stand installation
instructions are provided in case the stand was removed.
NOTE: If the large, hollow rubber bumper feet described
in step 4 of ‘Removing the Stand’ have been installed on
the bottom of the Cinema i cabinet leave them in place
when re-installing the stand.
NOTE: The Cinema i uses 2 types of rubber feet. The feet
refered to in ‘Installing the Stand’ are small and mushroom
shaped and are installed on bottom of the metal stand.
Required hardware (included):
Assembled stand, (4) small mushroom shaped rubber feet
(may already be installed), (6) 5/8“ x 5/32” Allen tool button
head bolts
Required tools (not supplied):
5/32” Allen tool
Removing the Stand
Figure 5. Removing the Cinema i stand.