8 Stand Options
1 Prepare a flat surface with padding and sheets to protect
the Cinema i as you work on it. Disconnect any wires and
carefully place the Cinema i upside down on the work
surface, using books or pieces of cardboard to keep the
speaker from rocking.
2 Line up the 6 holes on the metal brackets (3 per side)
with the threaded inserts on the bottom of the Cinema i
(figure 6, step A).
3 By hand, thread 5/32“ Allen bolts into the front 2 threaded
inserts (1 per side) that are nearest the woofers. Then,
thread in the remaining 4 bolts (2 per side) and tighten
each one with the 5/32” Allen tool (figure 6, step B).
4 Make sure that the stand’s 4 small rubber feet are installed
in the 4 outer holes located on bottom of the stands
center piece. If the small rubber feet have been removed
from the stand they can be easily reinserted by slightly
moistening the feet and twisting them into the holes
with firm pressure (figure 6, step C).
5 Place the Cinema i in the desired location. Make certain
it is stable, secure, and protected from being bumped.
NOTE: These instructions describe how to remove the stand
from the Cinema i and mount it to the wall. MartinLogan
recommends using 6 wall anchors to secure the Cinema i
to the wall. Most installations will use the outer 4 holes and
two center holes. The outer two sets of holes are 16” on
center. If any of the sets of holes hits a stud, it is recom-
mended to directly screw into the stud.
Required hardware (included):
(6) wall anchors, (6) 1“ Phillips head screws
Required tools (not supplied):
5/32” Allen tool, a 2 ft. level or a 2 ft. board and a small
level, an electric drill and 1/4“ and 1/8“ drill bits, Phillips
screw driver
NOTE: These instructions assume the mounting surface is
of wood frame and standard sheetrock construction. If you
wish to mount the Cinema to another type of material or
construction, you should consult a bonded contractor.
WARNING! This operation requires 2 people. Do
not attempt to install your Cinema i on a wall or
ceiling by yourself
WARNING! For safety reasons, the Cinema i is
shipped with four small rubber feet installed on
the bottom of the metal stand. If the stand is being
mounted on a wall, these small rubber feet must
be removed.
1 Prepare a flat surface with padding and sheets to protect
the speaker as you work on it. Disconnect any wires and
carefully place the Cinema i upside down on the work
surface, using books or pieces of cardboard to keep the
speaker from rocking.
2 Make sure that the 4 small rubber feet on the bottom of
the Cinema i’s metal stand are removed. If they are not,
do so at this time by gently pulling and rocking them out
of the holes (figure 7, step A).
Mounting the Cinema i On A Wall
Figure 6. Attaching the Cinema i stand.