1.Locate and mark the center point where you would like to position the Cinema Adjustable Mount. Measure 17 inches horizontally in each direction from the center point. This area must be clear of any obstructions in order to mount the Cinema. Also, make certain there will be at least 6 inches of clearance above or below in order to install the knobs and tilt the speaker up or down.

2.Using a #2 phillips bit and an electric drill, drive a wall anchor into the wall on the center point.

3.Unscrew the two large knobs and remove the two Metal Shelf Brackets from the Cinema Stand. Set the 2 rubber washers, the 2 plastic washers and the large knobs aside for use in a later step.

4.Place the Cinema Stand carefully against the wall and align its uppermost center hole over the wall anchor. Using one of the 11/4" in. phillips head screws, mount the Cinema Stand to the wall. Do not fully tighten the screw as you must first level the stand before marking the remaining holes.

5.Place a level across the top edge of the Cinema Stand and make sure that it is level. Then, consult the illustration and mark the wall through the center of each of 5 holes in the Cinema Stand.

6.Remove the Cinema Stand and drive a wall anchor at each of the 5 marks.

7.With the help of an assistant, place the bracket against the wall and attach it to the wall anchors using the (6) 11/4 in. phillips head screws. Tighten the screws but be very careful not to over tighten them and strip out the wall anchors.

8.Attach the Metal Shelf Brackets to the Cinema Stand. Place a carriage bolt through a Metal Shelf Bracket so that it points inward toward the center of the stand. Place the rubber washer between the Metal Shelf Bracket and the stand, push the bolt through the stand, place a plastic washer over the bolt and thread on to the large knob. Hand tighten and repeat each step for the other side. Make certain the Metal Shelf Brackets are parallel to the floor and tighten each large knob.

9.Remove the 2 protective foam pads from the bottom of each of the woofer boxes if they are attached to the Cinema. Failure to remove the foam pads may result in damage to the speaker cabinet.

10.Set the Cinema on the Metal Shelf Brackets. By hand, thread the 3/4 in. button head Allen screws into the front two threaded inserts that are closest to the woofers. Next, thread in the 4 remaining screws. Tighten each screw with the 5/32 Allen wrench.

11.To direct the speaker to the desired listening position, while supporting the Cinema with one hand, slightly loosen the large knobs with the other. Tilt the Cinema to its best advantage and securely tighten each knob.

12.Attach the speaker cable and AC power cord. Enjoy!

Fig. A - Unpack the Cinema

Adjustable Mount.

Fig. B - Assemble the Cinema

Adjustable Mount.

Fig. C - Attach the Cinema

Adjustable Mount to the

Cinema.

Fig. D - Attach the Adjustable Mount to a wall or ceiling using the 6 wall anchors and 6 Allen screws.

c l se l e c t r o s t a t i c

M A R T I N L O G A N

2101 Delaware Street, Lawrence, Kansas 66046, USA tel 785.749.0133 fax 785.749.5320 www.martinlogan.com

©2000 MartinLogan, All rights reserved

Page 2
Image 2
MartinLogan TV Mount manual R T I N L O G a N