Marvel Industries 3BARM manual 6BARM BEVERAGE CENTER FEATURES

Models: 6BARM 3BARM

1 12
Download 12 pages 52.32 Kb
Page 7
Image 7
6BARM BEVERAGE CENTER FEATURES

6BARM BEVERAGE CENTER FEATURES

Insert Wine Bottles

The wine rack pull-out shelf holds eight (8) bottles. See Figure 7 for typical wine bottle orientation. The wine rack can be located at the middle or bottom part of the inte- rior cabinet. For red wines, place wine shelf at bottom shelf position in the cabinet. Then put a glass shelf in the next higher position. For white and sparkling wines, put the wine shelf on the middle shelf position in the cabinet. Place the remaining shelves as desired (see Figure 8). Also, there is a fixed, wooden, bottle cradle in the bottom, step section of the cabinet. Six (6) bottles may be stored there.

Loading Tips and Suggestions

The glass shelves and fixed position wire rack are for general beverage storage, such as beer and soft drinks. Opened wine bottles and tall beverage containers may be stored on the glass shelf closest to the cabinet top. Just lift the hinged section of the fixed position upper wire rack to provide clearance for the bottles and/or containers to stand upright.

The wooden, bottom bottle cradle may be removed for storing “jug” wines. Just remove the two (2) screws that secure the cradle to the cabinet floor.

You may store magnums and other large bottles on any of the racks (except for the top rack) by removing the rack directly above them. Position white wines on the middle or lower racks and red wines on the upper racks (see Figure 9).

The bottles on the top rack directly under the light will be exposed to a slightly higher temperature when the light is on. Position your wines accordingly and REMEMBER TO TURN OFF THE LIGHT WHEN IT IS NO LONGER NEEDED.

Keep wines that you plan to use for everyday drinking and entertaining on the front half of the racks where labels are completely visible. Place wines for aging or longer term storing in the rear.

Pull-out Racks

The pull-out wine rack may be pulled out approximately seven and a half (7.5) inches to facilitate adding or remov- ing bottles. Do NOT lean on or press down heavily on the wine shelf. Doing so may damage the shelf and the wine bottles stored on it. Pull the wine rack out gently and care- fully to minimize unsettling your wine collection. AVOID pulling out more than one rack at any time to maintain stability.

Single Bottle Racks

Since bottles are not stacked on top of each other, you can easily view and access your inventory without disturbing other bottles (see Figure 9).

Front Bottles (Necks Facing Rear)

Rear Bottles (Necks Facing Front)

Figure 7

Figure 8

Figure 9

6

Page 7
Image 7
Marvel Industries 3BARM manual 6BARM BEVERAGE CENTER FEATURES