TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | CORRECTION |
|
|
|
Odor in cabinet | • Unit interior needs cleaned. |
• Clean inside of unit. See “Care and Cleaning” pg. 7.
Noisy operation | • | Unit not level. | • Adjust leveling legs. See leveling leg instructions. | |
Unit vibrates | • | Unit not level. | • Adjust leveling legs. See leveling leg instructions. | |
| • | Weak floor. | • Rebuild floor or move to a different location. | |
Interior light not working | • | LED light burned out. | • | Replace LED light. |
| • No power at outlet. | • Test outlet with lamp. | ||
Appliance will not run. | • | Control Panel turned “OFF”. | • Turn unit on with on/off pad on Control Panel. | |
| • Line Cord not plugged into power | • Plug unit into power source. | ||
|
| source. |
|
|
| • | House fuse blown. | • | Reset house fuse. |
Appliance runs too long. | • | Prolonged door openings. | • Reduce number and/or duration of door openings. | |
| • Control Panel set too cold. | • Raise temperature of unit via Control Panel. | ||
| • | Condenser needs cleaning. | • Clean condenser. See “Care of Unit” pg 7. | |
Moisture collects inside of unit | • | Too many door openings. | • Reduce number and/or duration of door openings. | |
| • | Prolonged door openings. | • Reduce number and/or duration of door openings. | |
| • Hot, humid weather increases | • As humidity decreases, moisture will disappear. | ||
|
| condensation. | • Move unit to cooler location. | |
Moisture collects on outside | • | Hot, humid weather increases | • As humidity decreases, moisture will disappear. | |
surface of the unit. |
| condensation. | • Move unit to cooler location. | |
| • | Control improperly set. | • Reset to slightly warmer temperature. | |
Interior too hot/too cold | • | Control improperly set. | • Reset control to desired temperature. | |
| • | Faulty thermometer. | • Recheck with second thermometer. |
Diagnostic LED
In the back in the grille there is a diagnostic/status LED. This led is used to help diagnosis any problems with the unit and to tell its status.
LED Status | Code/Problem |
Not on | Unit does not have power |
Continuously on | Unit is "ON" and operating correctly |
1 Blink and pause | For shorted or open thermistor |
2 Blink and pause | Disconnected Display Board |
3 Blink and pause | Compressor is locked out |
8