Massey Ferguson L&G 1694404 Remote Deflector Control Template, Mounting Remote Deflector Control

Remote Deflector Control Template

Line Template Up with Edge of Plastic Dashboard

Mark and Drill One

9/32” Hole Mount Bracket and align with Line

Mark and Drill One 9/32” Hole

Figure 28. Template Location

MOUNTING REMOTE DEFLECTOR CONTROL

NOTE: Read through instructions before beginning.

1.Open the hood.

2.Cut out the template and place it on the lower left cor- ner of the dashboard as shown above.

3.Mark and drill one 9/32” hole using the template to locate the holes.

4.Mount the remote deflector mounting bracket (E, Figure 29) control to the dashboard using upper hole.

5.Align center of lower hole to dashed line on template and mark. Remove the remote deflector mounting bracket (E). Drill one 9/32” hole using the marked location.

6.Mount the remote deflector mounting bracket (E) con- trol to the dashboard. Secure using two 1/4-20 x 7/8” capscrews (A) through the bracket (E) and dash- board.

7.Secure with 1/4 x 1-1/4 flatwashers (B), lockwashers (C), and nuts (D) on the BACKSIDE of the dash- board.

DO NOT OVER-TORQUE. Over-torquing may crack the dashboard.

	E
D	A
C	B

Figure 29. Mount Control Bracket - Current Models

A. 1/4-20 x 7/8 Capscrews	D. 1/4-20 Nuts
B. 1/4 x 1-1/4 Flatwashers	E. Mounting Bracket
C. 1/4 Lockwashers

20