Operating Instructions
The proper amount of heat for each application is dependent upon the distance of the nozzle from the work surface and the length of time that heat is applied to the work surface.
Before performing any application, we recommend that you experiment with a piece of scrap material. Use care in approaching the work until you find the proper combination of heat adjustment control, distance from the work surface, and the heat application time.
Use a gentle back and forth motion when applying heat unless it is found that a concentrated heat is desired.
Typical Applications
To Operate Heat Gun
1)Plug heat gun into properly rated outlet.
2)Move rocker switch to “Hot” position. Heat gun will come up to operating temperature in approximately two minutes.
3)Move switch to "Off" position.
CAUTION: Do not place unit on its side while using spreader or heat shrink attachments.
Shrink Packaging |
| Strip Paint |
| Install Vinyl |
Use low or high heat |
| Use low or high heat |
| Use low or high heat |
|
|
|
|
|
|
|
|
|
|
Shrink Tubing | Bend PVC Tubing | Dry Film |
Use low or high heat | Use high heat | Use low heat |
5
