Master Bilt IM-23GB manual Introduction, Store Conditions

INTRODUCTION

Thank you for purchasing Master-BiltIce Merchandiser. This manual contains important instructions for installing, using, cleaning, and servicing Master-BiltIndoor Ice Merchandiser. A parts list is included with this manual. Read all documents carefully before installing or servicing your equipment.

STORE CONDITIONS

The Master-BiltIce Merchandisers are designed to operate in a controlled environment. The temperature should be at 75°F or below for an indoor ice merchandiser, with relative humidity of 55% or less. At higher temperature or humidity conditions, the performance of these merchandisers may be affected and the capacity diminished.

The Master-BiltIce Merchandiser should not be positioned where it is directly exposed to rays of the sun or near a direct source of radiant heat or airflow. This will adversely affect the ice merchandiser and will result in poor performance.

If this ice merchandiser is to be located against a wall, there should be at least 6” space between the wall and the back of the unit. This space will allow for the circulation of air behind the ice merchandiser, which will prevent condensation on the exterior surfaces.

WARNING LABELS AND SAFETY INSTRUCTIONS

This symbol is the safety-alert symbol. When you see this symbol on your ice merchandiser or in this manual, be alert to the potential for personal injury or damage to your equipment. Be sure you understand all safety messages and always follow recommended precautions and safe operating practices.

NOTICE TO EMPLOYERS

You must make sure that everyone who installs, uses or services your cabinet is thoroughly familiar with all safety information and procedures.

Important safety information is presented in this section and throughout the manual. The following signal words are used in the warnings and safety messages:

DANGER: Severe injury or death will occur if you ignore the message.

WARNING: Severe injury or death can occur if you ignore the message.

CAUTION: Minor injury or damage to your cabinet can occur if you ignore the message.

NOTICE: This is important installation, operation or service information. If you ignore the message, you may damage your cabinet.

The warning and safety labels shown throughout this manual are placed on your Master-Bilt Products cabinet at the factory. Follow all warning label instructions. If any warning or safety labels become lost or damaged, call your customer service department at (800)684-8988 for replacements

CAUTION!

GROUND REQUIRED

FOR SAFE OPERATION

This label is attached on the cabinet back and in the machine compartment.

This label is located on the power cord.

4