Instructions For Cleaning
CAUTION: Grill surfaces are hot during use. Allow Grill Plate, Drip Tray, Lid and Grill Base to cool completely before handling and cleaning.
1.Turn the Temperature Control Knob to the LOCK/OFF position and allow the Grill to cool before disassembling and cleaning.
2.Remove the propane cylinder.
3 Remove the Grill Plate and empty the Drip Tray.
4.Wash the Grill Plate and Drip Tray with warm, soapy water and a plastic scouring pad. Rinse and dry thoroughly. Do not use steel wool, coarse scouring pads or harsh or abrasive cleaners. If necessary, use a nylon bris- tle brush to loosen hardened food particles.
5.Wash the inside of the Lid with a solution of mild detergent and water or use a grill cleaner with nylon bristle brush. Rinse and allow to completely air dry. Do not use a caustic grill cleaner.
6.Wash exterior parts with a soft sponge and warm clear water. Nonabrasive cleaners may also be used.
7. Use a damp cloth to clean the inside | Bottom View of |
of the Grill Base. | Regulator Assembly |
Cleaning the Burner Assembly |
| |
IMPORTANT: Clean burner assembly prior |
| |
to use after storing, at the beginning of |
| |
grilling season or an inactive period of one |
| |
month. Spiders and insects like to build |
| |
nests in burner tubes, especially during |
| |
colder months. The nests can cause fires | Clip | |
in burner tubes or under grill. | ||
(P/N 21643) | ||
| ||
In order to clean the inside of the burner |
| |
tubes, the Burner Assembly must be |
| |
removed from the Grill. Make sure the | Figure 11 | |
propane cylinder, Lid, Grill Plate and Drip | Venturi | |
Tray have been removed before proceed- | ||
ing. | Hex Nut | |
1. Turn the Grill Base upside down. Refer | ||
to Figure 11 and locate the clip that |
| |
holds the venturi to the Regulator |
| |
Assembly. Pull straight up on the clip |
| |
and set it to the side. |
| |
2. Refer to Figure 12 and locate the two |
| |
machine screws that secure the |
| |
Burner Assembly to the Grill. Loosen |
| |
and remove these screws, making |
| |
sure you retain the screws, washers | Machine Screw | |
and hex nuts for reassembly. | and Washer |
Figure 12
16