Before First Use
1.Remove the Grill and any packaging materials.
2.Place the Base Frame on a flat, level surface.
3.Slide the Transport Lock to the right and raise the Transport Handle from the storage position.
4.Remove the Grill Plate, Grill Base, Lid and Drip Tray. Wipe the Grill Base and Lid with a damp cloth to remove any dust. Wash the Grill Plate and Drip Tray in warm, soapy water. Rinse and dry thoroughly.
5.The Handle/Vent and mounting
hardware, (Screw/Washer) are |
| Handle/Vent |
shipped in an inverted fashion, |
| Vent Slot |
requiring minor assembly. |
| |
|
| |
Remove the Handle/Vent from |
| Lid |
the inside of the Lid by unscrew- |
|
|
ing the Screw/Washer. Remove |
|
|
all parts, then properly position |
| Screw/Washer |
the Handle/Vent on the top of the |
| |
Lid. Make sure the Handle/Vent |
| Figure 1 |
stop pin enters the Vent slot in |
| |
the Lid. From the inside of the |
|
|
Lid, place the Screw/Washer | Drip Tray | Slots for |
through the hole in the Lid and |
| Drip Tray |
Handle/Vent. Securely fasten |
| Hook the |
with a Phillips head screw driver. |
| |
| Slotted | |
See Figure 1. |
| |
| Bracket | |
6. Slide the Drip Tray into the slots |
| |
| Under Base | |
in the Grill Base. |
| |
| Frame | |
7. See "Grilling Positions" on the |
| |
| Locator Peg | |
following pages and place the |
| Locator |
Grill Base on the Base Frame. |
| |
| Peg | |
Refer to Figure 2 and hook the |
| |
|
| |
Slotted Bracket around the |
|
|
Locator Peg under the Base |
| Figure 2 |
Frame. Align the hole in the Grill |
| |
Base with the Locator Peg on |
|
|
the opposite side of the Base |
|
|
Frame. |
|
|
8. Place the Grill Plate on the Grill Base and place the Lid over the Grill Plate.
NOTE: If the Lid is to be removed temporarily it may be placed between the Grill and the Wheels as shown in Figure 3.
Figure 3
7