Level, Warm Wash/Cold Rinse and 6 minutes of GEN- TLE agitation. "Wash 6 Minutes" will appear in the
Monitor. (To change these options see the following section.) Use this cycle for delicately constructed
knits, sheer fabrics, lingerie and washable woolens,
Customized Care Cycles
The Custom Cycle 1 and Custom Cycle 2 pads can each be programmed with a customized cycle to care for special loads,
To program, first press the desired cycle pad (Regular, Perm. Press, etc.) and make the necessary changes in
wash tcinperature, water level, wash time, rinse selee- tions and options. When all the selections have been
made, press the custom pad and hold until a long tone is heard,
NOTE: the first time CUSTOM CYCLE pads are used, the pad must be held until three tones are
heard followed by the long tone.) The tone(s) indi- cates the customized cycle has been programmed, The next time that special cycle is needed, simply
press the custom pad. The custom cycles can be changed at any time by repeating this procedure.
Special Cycles
The FINE WASH cycle is designed for
appear in the Monitor. (To change these options see
the following section.) A liquid detergent is recom- mended when using this cycle.
The SOAK cycle is used to soak heavily soiled or stained items, without the washer advancing into a wash cycle. To select, press the soak pad. After a slight pause, the washer will fill and automatically select an Extra Large Water Level, Cold water and 30 minutes of soak
time with brief periods of agitation. "Soak 30 Minutes" will appear in the Monitor. (To change these options see
the following section.) After the soak period the washer will spin and drain the water. Generally, soak periods
up to 30 minutes are sufficient for most loads.
For an extended soak period, press and hold the • TIME ADJUST pad until two dashes
Monitor. The washer will fill, briefly agitate, shut off and continue to soak for an infinite length of time
(overnight soaking is not necessary or recom- mended).
After the desired soak time, press the SPIN pad to drain the water. After soaking, the load should be laundered with detergent.
I
I NOTE: Allow the washer to complete the entire I spin cycle (5 minutes) to avoid the next cycle begin-
I ning with a spin.
The RINSE cycle is used when only"a rinse is desired. To select, press the Rinse pad. After a slight pause, the washer will fill and automaticalIy select an Extra Large Water Level, Cold water and 2 minutes of agitation.
"Riuse 2 Minutes" will appear in the Monitor. (To change the water level and agitation time see the fol- lo,adng section.)
If a warm rinse is preferred, press the WARM RINSE pad under OPTIONS.
PAGE 5