Break off tag A on the cup fitted on the right side and tag B on the cup fitted on the left side. Then remove the paper from the self- adhesive surface under the plastic cups.
A
B
4. Fit the plastic cups so that the “tags” marked with arrows are against the front edge of the cover and side edge and press firmly onto the cover. Then break off the remaining tags.
5. Push the tumble dryer in under the metal angles, keeping the front edge raised 1 - 2 cm.
6. Lower the tumble dryer’s front feet into the plastic cups and adjust so that the dryer is balanced.
Adjusting the feet
Screw the feet in or out so that the tumble dryer is steady and balanced on the floor or on the washing machine. Then tighten the locking nuts.
Locking nut
Condensed water
The machine is supplied as shown in Option 1 (inset). This means that the condensed water is pumped into the con- densed water container. This must then be removed and emptied by hand.
Option 2 allows you to remove the small short hose from the blue nipple. Then at- tach the enclosed rubber hose to the blue nipple. The water can then be pumped out into a laundry sink or a floor drain (2a).
2
1
Max. | 1,000mm |
2a |
|
19
