Surface Cooking
Smoothtop Surface
Smoothtop Surface Notes:
•Cooktop may emit light smoke and odor the first few times the cooktop is used. This is normal.
•Smoothtop cooktops retain heat for a period of time after the element is turned off. Turn the elements off a few minutes before food is completely cooked and use the retained heat to complete cooking. When the hot surface light turns off, the cooking area will be cool enough to touch. Because of the way they retain heat, the smoothtop elements will not respond to changes in settings as quickly as coil elements.
•In the event of a potential boilover, remove the pan from the cooking surface.
•Never attempt to lift the cooktop.
•The smoothtop surface may appear discolored when it is hot. This is normal and will disappear when the surface cools.
Cooking Areas
The cooking areas on your range are identified by permanent circles on the smoothtop surface. For most efficient cooking, fit the pan size to the element size.
Pans should not extend more than 1/2 to
When a control is turned on, a glow can be seen through the smoothtop surface. The element will cycle on and off to maintain the preset heat setting, even on Hi.
For more information on cookware, refer to Cookware Recommendations on page 6.
| 9" SINGLE |
|
| ELEMENT | 6" SINGLE |
6" SINGLE |
| |
| ELEMENT | |
ELEMENT |
| |
|
|
12" SINGLE
POWER BOOST
ELEMENT
Hot Surface Light
The Hot Surface indicator light is located at the front of the cooking surface. The light will be illuminated when any cooking area is hot. It will remain on, even after the control is turned off, until the area has cooled.
Tips to Protect the
Smoothtop Surface
Cleaning (see page 17 for more information)
•Before first use, clean the cooktop.
•Clean your cooktop daily or after each use. This will keep your cooktop looking good and can prevent damage.
•If a spillover occurs while cooking, immediately clean the spill from the cooking area while it is hot to prevent a tough cleaning chore later. Using extreme care, wipe spill with a clean dry towel.
•Do not allow spills to remain on the cooking area or the cooktop trim for a long period of time.
•Never use abrasive cleansing powders or scouring pads which will scratch the cooktop.
•Never use chlorine bleach, ammonia or other cleansers not specifically recommended for use on
To Prevent Marks and Scratches
•Do not use glass pans. They may scratch the surface.
•Never place a trivet or wok ring between the surface and pan. These items can mark or etch the top.
•Do not slide aluminum pans across a hot surface. The pans may leave marks which need to be removed promptly. (See Cleaning, page 17.)
•Make sure the surface and the pan bottom are clean before turning on to prevent scratches.
•To prevent scratching or damage to the
•Never slide heavy metal pans across the surface since these may scratch.
cont.
5
