Maytag SE1000 operating instructions Select the Drying Cycle, Permanent Press

I.SELECT THE DRYING CYCLE

Regular --

Use this cycle for nonpermanent press loads such as towels, underwear, etc. If you touch the "Regular" pad, the dryer will immediately begin operating, automatically selecting the regular temperature and the normal dryness level. ("E2" appears in display.) At the end of the cycle there is a 5-minute cool period ("Cool" light turns on), and an electronic tone will sound four times when the dryer shuts off. During the cool down period, the cool time remaining is shown in the display.

Permanent Press --

Use this cycle for permanent press loads or no-iron fabrics such as nylon, acrylic, polyester or blends. If you touch the "Permanent Press" pad, the dryer will immediately begin operating, automatically selecting the regular temperature and normal dryness level. ("E2" appears in display.) At the end of the cycle there is a 10-minute cool-down period. ("Cool" light turns on.) The display counts down the last 7 minutes of the cool_down period with the electronic tone sounding 4 times every 20 seconds. The signal can be turned off by touching the "Signal On/Off" pad.

NOTE: You can change back and forth from Regular to Permanent Press program any time during the cycle.

m SELECT THE DRYING TEMPERATURE

Regular Temperature --

This temperature is automatically selected on both the Regular and Permanent Press programs and would be used for

drying most Regular and Permanent Press loads. This would include those garments labeled "Tumble Dry," "Tumble Dry

Medium," etc.

Delicate Temperature --

Touch the "Delicate Temp" pad to select this temperature; touch the pad again to cancel the delicate temperature

selection (returns to regular temperature). Use the delicate temperature for drying those heat sensitive garments labeled

"Tumble Dry Low," "Tumble Dry Warm," etc.

a SELECT THE DRYNESS LEVEL

E1 Less Dry --

To select this dryness level, press the "LESS" pad. This setting would be used for lightweight synthetic loads or loads you wish to have slightly damp.

E2 Normal Dry --

This dryness level is automatically selected on both the Regular and Permanent Press programs. This dryness level would be used for the majority of loads.

E3 More Dry --

To select this dryness level, press the "MORE" pad. This setting would be used to completely dry heavyweight, hard-to- dry loads such as rugs and work clothes or for extra dryness of any load.

NOTE:	The "OFF" pad	can	be	touched	any time to shut off	the	dryer,	canceling all selections.	After removing a load, if a
	symbol remains	in	the	display,	clear it by touching	the	"OFF"	pad.