Looped power cord | Level the Washer |
| Properly leveling your washer avoids excessive noise and vibration. |
| Install the Front Leveling Feet |
| 1. Prop up the front of the washer about 4" (10.2 cm) with a wood block or similar object. |
| The block needs to support the weight of the washer. |
Looped power cord
1. Firmly grasp the yellow shipping strap and pull until both ends are completely removed from washer.
A
2.Check that two (2) cotter pins were removed with the shipping strap.
4"
(10.2 cm)
A. Threaded holes for feet
2.Screw the locknut onto each foot to within 1" (2.5 cm) of the foot base.
1"
(2.5 cm)
3.Screw the feet into the threaded holes at the front corner of the washer until the nuts touch the washer. Twist the feet to install.
NOTE: Do not tighten the nuts until the washer is level.
4.Tilt the washer back and remove the wood block. Gently lower the washer to the floor.
9
