Maytag W10150638A, W10150639A Dyer Care, Cleaning the Dryer Location, Cleaning the Lint Screen

Models: W10150639A W10150638A

1 56
Download 56 pages 31.28 Kb
Page 22
Image 22

1.Open dryer door.

A

A. Front edge

2.Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure over the lint screen.

B

A

A. Dryer rack front edge

B. Dryer back panel

3.Put the wet items on top of the drying rack. Leave space between the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the drying rack.

4.Close the door.

5.Select a Manual cycle, and choose a temperature or Air Only (see following chart). Items containing foam, rubber or plastic must be dried on a clothesline or by using the Air Only temperature setting.

6.You must select a time by pressing the MANUAL DRY TIME (- or +) buttons. Reset time as needed to complete drying. Refer to the following table.

7.Press (and hold) HOLD TO START button (about 1 second).

NOTE: You must remove drying rack for normal tumbling. Do not use automatic cycles with the drying rack.

This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold.

Rack Dry

Setting

Temp.

Time*

 

 

 

 

Wool Sweaters

Timed Dry

Low

60

Block to shape and lay flat on the drying rack

 

 

 

 

 

 

 

Stuffed toys or pillows

Timed Dry

Low

60

Cotton or polyester fiber filled

 

 

 

 

 

 

 

Stuffed toys or pillows

Timed Dry

Air Only

90

Foam rubber filled

 

(no heat)

 

 

 

 

 

 

 

 

Sneakers or canvas shoes

Timed Dry

Air Only

90

 

 

(no heat)

 

 

 

 

 

*(Minutes) Reset time to complete drying, if needed.

DYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

Cleaning the Lint Screen

Every load cleaning

The lint screen is located in the door opening of the dryer. A screen blocked by lint can increase drying time.

To clean

1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

22

Page 22
Image 22
Maytag W10150638A, W10150639A manual Dyer Care, Cleaning the Dryer Location, Cleaning the Lint Screen, Every load cleaning