COMPACTOR CARE
Your new compactor is designed to give you many years of dependable service. However, there are a few things you are expected to do in order to properly maintain your compactor. This section will tell you how to clean and care for your compactor.
Changingthe Charcoal Air Filter
To order the correct replacement charcoal filters call the
1.Insert fingertips in the Air Filter Cover and pull until the side tabs release. Then, lift the cover to release the bottom tabs.
2.Remove the Air Filter by pulling the top edge of the filter. The filter should pull out easily. Throw away used filter.
3.To replace, push the replacement filter into place. Insert the bottom tabs of the Air Filter Cover and push in until the side tabs snap into place.
Cleaning
Before cleaning the compactor, turn the
NOTE: Any services other than those outlined in this section should be performed by a designated service representative.
Cleaning Exterior Surfaces
1.Wash exterior surfaces (including stainless steel) with a clean sponge or soft cloth and a mild detergent in warm water. Do not use abrasive or harsh cleaners. Rinse and dry thoroughly with a soft cloth.
2.Wipe up spills right away. Some foods can damage the finish if left on the compactor surface.
Cleaning Inside the Drawer
NOTE: You may want to wear protective gloves as there may be bits of glass in the drawer.
1.Remove the bag. See the “Removing a Filled Bag.”
2.Press down on the
3.Hold the
NOTE: If desired, the drawer side can be removed by tilting it up, then lifting it out.
4.Wash the interior of the drawer with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth.
5.If the drawer side was removed, slide it back into the tilted position.
6.Press the
7.Latch the drawer side by pushing up the
12
