Maytag W10157503D manual Water Inlet Hoses, Vacation, Storage, and Moving Care

If using liquid chlorine bleach:

Open the dispenser drawer and immediately add 2/3 cup (160 mL) of liquid chlorine bleach to the bleach compartment.

NOTE: Do not add any detergent to this cycle. Use of more than 2/3 cup (160 mL) of bleach will cause product damage over time.

3.Close the washer door and dispenser drawer.

4.Select the Clean Washer cycle.

5.Press START/PAUSE.

NOTE: The basket will rotate, then the door will unlock, lock again, and then the cycle will continue.

„The machine will bring in some inlet water, and the basket will rotate while the washer runs a short sensing cycle. This will take approximately 3 minutes.

6.The cycle will determine whether clothing or other items are in the washer.

a)If no items are detected in the washer, it will proceed to Step 7.

b)If any items are detected in the washer, “rL” will be displayed, and the WASH and CONTROLS LOCK lights will remain lit. The door will unlock. Open and remove any garments in the wash drum.

„Press POWER/CANCEL to cancel the failure code. Then repeat steps 3, 4, and 5 to start the cycle again.

7.Once the cycle has begun, allow the cycle to complete.

8.After the cycle is complete, leave the door open slightly to allow for better ventilation and drying of the washer interior.

Always do the following to maintain washer freshness

„Use only HE High Efficiency detergent.

„Leave the door slightly open after each cycle to allow for better ventilation and drying of washer interior.

„Repeat the cleaning procedure monthly or when the CLEAN WASHER REMINDER light illuminates.

„If you are not ready to run the Clean Washer cycle, but the Clean Washer Reminder light is illuminated, press the Clean Washer Reset button.

If the procedure does not sufficiently improve the machine freshness, evaluate your installation and usage conditions for other causes.

Cleaning the Dispenser Drawer

The dispenser drawer is removable for easy cleaning.

1.Open the dispenser drawer. Unlock the dispenser drawer by pressing the Release Lever on the left side of the dispenser drawer. See “Using the Dispenser”. Remove the drawer.

2.Wash the dispenser under running water to clean. Allow to dry.

3.Return the dispenser to drawer.

Cleaning the exterior

Use a soft damp cloth or sponge to wipe up any spills. Occasionally wipe the outside of your washer to keep it looking new. Use mild soap and water. Do not use abrasive products.

Water Inlet Hoses

Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, record the date of replacement.

Vacation, Storage, and Moving Care

Install and store your washer where it will not freeze. Because some water may stay in the hoses, freezing can damage your washer. If storing or moving your washer during freezing weather, winterize it.

Non-use or vacation care:

Operate your washer only when you are at home. If you will be on vacation or not using your washer for an extended period of time, you should:

„Unplug washer or disconnect power.

„Turn off the water supply to the washer. This helps avoid unintended flooding (due to a water pressure surge) while you are away.

„Slightly open door to provide ventilation.

To winterize washer:

1.Put 1 qt (1 L) of R.V.-type antifreeze in the drum.

2.Run washer on a Drain & Spin cycle.

3.Unplug washer or disconnect power.

4.Shut off both water faucets.

5.Disconnect water inlet hoses from faucets and drain.

To use washer again:

1.Flush water pipes. Reconnect water inlet hoses to faucets. Turn on both water faucets.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

2.Plug in washer or reconnect power.

21