Begin procedure

1.Open the washer door and remove any clothing or items from the washer.

2.Using the AFFRESH™ washer cleaner (Recommended):

Add one AFFRESH™ washer cleaner tablet to the washer drum.

If using liquid chlorine bleach:

Open the dispenser drawer and immediately add ²⁄₃ cup (160 mL) of liquid chlorine bleach to the bleach compartment.

NOTE: Do not add any detergent to this cycle. Use of more than ²⁄₃ cup (160 mL) of bleach will cause product damage over time.

3.Close the washer door and the dispenser drawer.

4.To start the Clean Washer cycle, first enter “Start Operating Setup.” Then press and hold DELICATES & KNITS for 1 second. With the entire display flashing, press BRIGHTS.

NOTE: The basket will rotate, then the door will unlock, lock again, and then the cycle will continue.

The machine will not fill, but the basket will rotate while the washer runs a short sensing cycle. This will take approximately 3 minutes.

5.The cycle will determine whether clothing or other items are in the washer.

a)If no items are detected in the washer, it will proceed to Step 7.

b)If any items are detected in the washer, “rL” or “F-34” will be displayed. Then the door will unlock.

Press DELICATES & KNITS to cancel the failure code. Then repeat steps 1, 3 and 4 to start the cycle again.

6.Once the cycle has begun, allow the cycle to complete.

7.After the cycle is complete, leave the door open slightly, to allow for better ventilation and drying of washer interior.

Always do the following to maintain washer freshness

Use only HE High Efficiency detergent.

Leave the door slightly open after each cycle to allow for better ventilation and drying of washer interior.

Clean the washer monthly using the Washer Maintenance Procedure, an AFFRESH™ tablet or ²⁄₃ cup (160 mL) of liquid chlorine bleach.

If the procedure does not sufficiently improve the machine freshness, please evaluate your installation and usage conditions for other causes.

Cleaning the exterior

Use a soft damp cloth or sponge to wipe up any spills. Occasionally wipe the outside of your washer to keep it looking new. Use mild soap and water. Do not use abrasive products.

Cleaning the dispenser drawer

The dispenser drawer is removable for easy cleaning.

1.Unlock the dispenser drawer by pressing the Release Lever. Remove the drawer.

2.Remove the inserts (the siphon from the softener and bleach compartments).

3.Wash the parts under running water.

NOTE: Do not wash components in the dishwasher.

4.Replace the inserts and return the dispenser to the drawer.

Water Inlet Hoses

Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.

When replacing your inlet hoses, record the date of replacement.

ASSISTANCE OR SERVICE

If you need assistance:

The Maytag Consumer Interaction Center will answer any questions about operating or maintaining your washer not covered in the Installation Instructions. The Maytag Consumer Interaction Center is open 24 hours a day, 7 days a week. Just dial 1-800 NO BELTS (1-800-662-3587)- the call is free.

When you call, you will need the washer model number and serial number. Both numbers can be found on the serial-rating plate located on your appliance.

Accessories

Enhance your washer with these premium accessories.

For more high-quality items or to order, call 1-800-901-2042,or visit us at www.maytag.com/ accessories. In Canada call: 1-800-807-6777or visit us at www.whirlpoolparts.ca.

Part Number

Accessory

8212638RP

6 ft (1.8 m) nylon braided space-saving fill hose, 90° elbow, hypro-

 

blue steel couplings. Safer than stainless steel. (2-pack)

8212487RP

5 ft (1.5 m) nylon braided fill hose. Safer than stainless steel. (2-pack)

8212526

Washer drip tray, fits under all

31682

All purpose appliance cleaner

1903WH

Laundry supply storage cart

W10135699

AFFRESH™ washer cleaner

18

Page 18
Image 18
Maytag W10165327A manual Assistance or Service, Water Inlet Hoses, Accessories