Maytag MDD8000AWS Prerinsed glasses or dish Loads, Controls Cycle Status Control Purpose Comments

CYCLE SELECTIONS

CYCLES DISH LOAD TYPES		DESCRIPTIONS		WASH TIME (HH:MM)
			Cycle	Cycle + Options	*Maximum
			Minimum	Minimum
	Use to quickly wash	This cycle does not dry.	0:30	none	none
	prerinsed glasses or dish
	loads.

You can customize your cycle by selecting an option.

See option selections. If you change your mind, press the option again to turn off the option, or select a different option. You can change an option anytime before the selected option begins.

*Maximum wash times depend on water temperature, heavy soil condition, dish load size and options selected.

NOTE: Dry time (fan running) is typically 4 hours after wash cycle. After 30 minutes of dry time, the clean light will illuminate. Anytime after the clean light is lit and the drawer is opened for longer than 30 seconds, the cycle will be terminated.

OPTION SELECTIONS

OPTIONS	DISH LOAD TYPES	DESCRIPTIONS	USE WITH:
	Loads containing tough,	Increases the target water temperature during the wash	Sensor Wash, Heavy
	baked-on food.	portions of the cycle.	Duty or Normal Wash
		Adds heat, wash time and water to the cycle.

To run your dishwasher at a later time or during off- peak hours.

Delays the start of a cycle up to 6 hours.	All cycles, except Rinse
Select a wash cycle and options. Press 6 Hour Delay. Press	Only
START/RESUME. Close the drawer firmly.

Control Lock To avoid unintended use of your dishwasher, or cycle and option changes during a cycle.

To turn on Lock, press and hold Control Lock for at least	Anytime
3 seconds.
To turn off Lock, press and hold Control Lock for at least
3 seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher drawer can be opened while the
controls are locked.

IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically compensate by adding time, heat and water as needed.

CONTROLS AND

CYCLE STATUS

CONTROL PURPOSE COMMENTS

To start or resume a wash cycle

If the drawer is opened during a cycle, a delay, or the power is interrupted, the Start/Resume indicator flashes. To restart the drawer, open the drawer, press Start/Resume and close the drawer firmly within 4 seconds.

To cancel wash	Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
cycle	drain completely. If the Cancel button is pressed a second time, the drawer will turn off.
To follow the	Clean indicator glows when a cycle is finished.
progress and status	Rinse aid low indicator light glows when the rinse aid dispenser needs to be refilled.
of your dishwasher
cycle

5