6.Push microwave oven against mounting plate and hold in place.
NOTE: If microwave oven does not need to be adjusted, skip steps
7.If adjustment is required, rotate microwave oven downward. Using 2 or more people, lift microwave oven off of mounting plate, and set aside on a covered surface.
8.Loosen mounting plate screws. Adjust mounting plate and retighten screws.
9.Repeat steps
10.With the microwave oven centered, and with at least one person holding it in place, insert bolts through upper cabinet into microwave oven. Tighten bolts until there is no gap between upper cabinet and microwave oven.
A
For Roof Venting Installation Only
11.Connect vent to damper assembly.
A B
A.Vent
B.Damper assembly (under vent)
A. Bolts
NOTES:
■Some upper cabinets may require bolts longer or shorter than 3¹⁄₄" (8.3 cm). Longer or shorter bolts are available at most hardware stores.
■Overtightening bolts may warp the top of the microwave oven. To avoid warping, wood filler blocks (installer to provide) may be added. The blocks must be the same thickness as the space between the upper cabinet bottom and the microwave oven.
A B
C
D
E
A. Upper cabinet bottom
B.Bolt
C.Hanging front edge
D.Microwave oven
E.Wood filler block
Complete Installation
1.Install filters. Refer to the User Instructions for filter placement.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
2.Plug microwave oven into grounded 3 prong outlet.
3.Reconnect power.
4.Check the operation of microwave oven by placing 1 cup
(250 mL) of water on the turntable, and programming a cook time of 1 minute at 100% power. Test vent fan and exhaust by operating the vent fan.
5.If the microwave oven does not operate:
■Check that a household fuse has not blown, or that a circuit breaker has not tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
■Check that the power supply cord is plugged into a grounded 3 prong outlet.
■See the User Instructions for troubleshooting information.
Installation is now complete.
Save Installation Instructions for future use.
9
