INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Steam Models
■Flat-blade screwdriver
■#2 Phillips screwdriver
■Adjustable wrench that opens to 1" (25 mm) or
■Level
■Wire stripper (direct wire installations)
■Vent clamps
■Caulking gun and compound (for installing new exhaust vent)
■Tin snips (new vent installations)
■¼" nut driver (recommended)
■Tape measure
■Pliers
A | B | C | D | E |
| A. Leveling legs (4) |
| D. Inlet hose with | |
| B. “Y” connector |
| connector |
|
| C. Short inlet hose |
| E. Rubber washer |
|
Remove parts package from dryer drum. Check that all parts are included.
Parts supplied:
4 Leveling legs
NOTE: Do not use leveling legs supplied with dryer if installing on a pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting. See “Electrical Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require metal exhaust system hardware available for purchase from the dealer from whom you purchased your dryer. For further information, please refer to the “Assistance or Service” section in your Use and Care Guide.
Optional Equipment
Refer to your Use and Care guide for information about the accessories available for your dryer.
2
