1.Unplug refrigerator or disconnect power.
2.Remove the base grille. Grasp the grille firmly and pull it toward you.
3.Starting with the
4.Remove the top hinge cover from
5.Disconnect the wiring plug located on top of the hinge by wedging a
6.Disconnect the water line by pulling back on the locking collar while pulling the water line out of the water line connector. See Connections graphic.
7.Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the
8.Using a ³⁄₈" hex wrench, remove the leveling leg brackets from the bottom of the cabinet. Keep screws for later use.
Replace Doors and Hinges
1.Assemble the parts for the top hinge as shown in Top Hinge graphic. Do not tighten the screws completely.
2.Replace the parts for the bottom hinge as shown in Bottom Hinge graphic. Tighten screws. Replace the refrigerator door.
NOTE: Provide additional support for the refrigerator door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.
3.Align the door so that the bottom of the refrigerator door aligns evenly with the top of the freezer drawer. Tighten all screws.
4.Reconnect the wiring plug on top of the
5.Reconnect the water line by pulling back the locking collar ring while firmly pushing the water line into the connector.
6.Check for leaks. Replace the top hinge covers.
Remove and Replace Refrigerator Drawer and Freezer Drawer
IMPORTANT: Two people may be required to remove and replace the freezer drawer. Graphics are included later in this section.
Remove Drawer Front
1.Open the drawer to full extension.
2.Loosen the two top screws attaching the drawer glide brackets to the drawer front. See Drawer Front Removal graphic.
NOTE: Loosen screws three to four turns. Keep the screws in the drawer front.
3.Remove the two bottom screws attaching the drawer glide brackets to the drawer front.
4.Lift the drawer front up and off the top screws. See Drawer Front Removal graphic.
Replace Drawer Front
1.Slide the drawer glides out of the compartment. Insert the two screws in the drawer front into the upper slots in the drawer glide brackets. See Drawer Front Replacement graphic.
2.Align the drawer glide brackets with the lower holes in the drawer front and refasten with the screws. See Drawer Front Replacement graphic.
3.Completely tighten the four screws.
Final Steps
1.Replace the base grille.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
2.Plug into a grounded 3 prong outlet.
3.Return all removable parts to doors and drawer and food to refrigerator and freezer.
6
