McCulloch 8823 manual Operating HEAVY-DUTY Steam Cleaner, Attaching Carry Handle

USING THE

HEAVY-DUTY STEAM CLEANER

OPERATING HEAVY-DUTY STEAM CLEANER

NOTE: Be sure that Water Reservoir has already been filled and that all desired accessories are connected before following these steps.

1.Plug grounded power cord into a convenient electrical outlet.

CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in properly installed 3-prong electrical outlets. Do not attempt to alter plug or circumvent this safety feature in any way.

2.Switch Lighted On/Off Switch to “On” position. Steam Ready Light will immediately illuminate.

NOTE: Steam Ready Light is illuminated while boiler is heating.

3.Steam Ready Light will deactivate in 2-8 minutes (depending on how much water is in Water Reservoir), indicating that boiler is heated and unit is ready to begin steaming.

4.Direct Steam Jet Nozzle (or other accessories) towards surface you desire to steam, and press Steam Button. To sanitize surfaces, point Steam Jet Nozzle, press Steam Button and hold approximately 1/2 inch from surface for at least 5 seconds. This will insure that you have killed germs and bacteria.

CAUTION: Always be sure that Steam Jet Nozzle and other accessories are pointed in a safe direction (away from yourself, other people, pets, and plants) before pressing Steam Button.

5.Keep Steam Button depressed for a continuous flow of steam. You may also slide the Steam Lock Switch forward while depressing the Steam Button to lock the Steam Button down. This will let you have a continuous flow of steam without having to hold down the Steam Button.

6.Using a slight back-and-forth motion over the area you are steaming will further enhance the cleaning process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime. Wiping the area while it is still wet is recommended, but use caution when wiping surfaces such as metal that may still be hot.

NOTE: During use, the Steam Ready Light may illuminate. This is normal. If you notice a drop in steam pressure, release Steam Button until Steam Ready Light deactivates once again.

7.Once steaming tasks are complete, immediately set Lighted On/Off Switch to “Off” position and unplug grounded power cord from electrical outlet. Follow steps under Proper Storage procedure on page 11 of this manual.

ASSEMBLING THE

HEAVY-DUTY STEAM CLEANER

ATTACHING CARRY HANDLE

1.Insert Carry Handle into Carry Handle hole on top of unit. Please refer to illustration for assistance with proper alignment (FIGURE 1).

2.Use enclosed magnetic screw driver and screw to securely fasten Carry Handle to unit.

FIGURE 1

ATTACHING MAIN ACCESSORIES

WARNING: Do not try to connect accessories while unit is emitting steam.

This section applies to the Steam Jet Nozzle, Squeegee, Floor Brush, Extension Wands and Triangle Brush.

1.Depress red lock/release button on main steam nozzle (FIGURE 2-A).

2.While still depressing lock/release button, slide Steam Jet Nozzle or other accessory over this button, so that rectangular hole in attachment aligns with lock/release button (FIGURE 2-B).

3.Once lock/release button and rectangular hole are properly aligned, button should click through hole and into place.

4.To remove Steam Jet Nozzle or other accessory, press in red lock/release button and pull attachment off of main steam nozzle.

FIGURE 2

10 7