McCulloch 96188000300 owner manual Setup, Unfolding the Handle, Installing the Discharge Chute

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.

Procedure	Description	Qty.	Use
1.	No parts required	–	Unfold the handle.
2.	Carriage bolts	5	Install the discharge chute.
	Flange nuts	4	Install the discharge chute.
	Washers	2	Install the discharge chute.
	Knob	1	Install the discharge chute.
	Chute	1
	Deflector	1

1. Unfolding the Handle

Procedure

1.Loosen the two handle knobs and pull out the two handle bolts until you can move the handle freely and rotate the handle to the operating position (Figure 2).

1

2

Figure 2

1. Handle knobs 2. Handle bolt

2. Tighten the handle knobs until they are snug (Figure 3).

2.Installing the Discharge Chute

5Carriage bolts

4Flange nuts

2	Washers
1	Knob
1	Chute
1	Deflector

Procedure

Install the discharge chute as shown (Figure 4).

1

3 4 4 5

2

3

6

		Figure 4
1. Deflector		4.	Washer
2.	Carriage bolts	5.	Knob
3.	Flange nuts	6.	Discharge chute

Figure 3

IMPORTANT: Do not overtighten the flange nuts;

5 otherwise you may damage the discharge chute.