ASSEMBLY
Protective gloves (not provided) should be worn during assembly.
ATTACHING THE BUMPER SPIKE
(If not already attached)
The bumper spike may be used as a pivot when making a cut.
1.Loosen and remove bar knob completely by lifting lever and turning counterclock- wise. Remove clutch cover.
2.Attach the bumper spike with the two screws as illustrated.
ATTACHING THE BAR & CHAIN
(If not already attached)
WARNING: Recheck each assem- bly step if the saw is received assembled. Al- ways wear gloves when handling the chain. The chain is sharp and can cut you even when it is not moving!
1.Move ON/STOP switch to the STOP position.
2.Loosen and remove bar knob completely by lifting lever and turning counterclock- wise.
Guide bar
Bar bolts
5.Carefully remove the chain from the pack- age. Hold chain with the drive links as shown.
Tip of
Bar
CUTTERS MUST FACE IN
DIIRECTION OF ROTATION
Cutters | Depth Gauge |
LOOSEN
3.Remove clutch cover and plastic ship- ping spacer (if present).
Clutch Cover
Bar Knob
Location of shipping spacer
4.Slide guide bar on bar bolts until guide bar stops against clutch drum sprocket.
Drive Links
6.Place chain over and behind clutch re- tainer, fitting the drive links in the clutch drum sprocket.
7.Fit bottom of drive links between the teeth in the sprocket in the nose of the guide bar.
8.Fit chain drive links into bar groove.
9.Pull guide bar forward until chain is snug in guide bar groove. Ensure all drive links are in the bar groove.
10.Install clutch cover. Be sure adjusting pin is in the adjusting pin hole in the guide bar.
CAUTION: It is very important when instal- ling the clutch cover that the adjusting pin aligns into the adjusting pin hole in the bar. Fail- ure to install the clutch cover correctly may re- sult in permanent damage to your chain saw.
Back view of clutch cover
Adjusting pin
11.Install bar knob and finger tighten only. Once the chain is tensioned, you will need to tighten bar knob.
7
