SBe alert to signs that the tree is ready to fall: cracking sounds, widening of the felling cut,
or movement in the upper branches.
SAs tree starts to fall, stop saw, put it down,
and get away quickly on your planned re- treat path.
SDO NOT cut down a partially fallen tree with your saw. Be extremely cautious with par- tially fallen trees that may be poorly sup- ported. When a tree doesn’t fall completely, set the saw aside and pull down the tree with a cable winch, block and tackle, or tractor.
CUTTING A FALLEN TREE
(BUCKING)
Bucking is the term used for cutting a fallen tree to the desired log length.
WARNING: Do not stand on the log being cut. Any portion can roll causing loss of footing and control. Do not stand downhill of the log being cut.
Important points
SCut only one log at a time.
SCut shattered wood very carefully; sharp pieces of wood could be flung toward oper- ator.
SUse a sawhorse to cut small logs. Never
allow another person to hold the log while cutting and never hold the log with your leg or foot.
SDo not cut in an area where logs, limbs, and roots are tangled. Drag the logs into a clear area before cutting by pulling out ex- posed and cleared logs first.
TYPES OF CUTTING USED FOR BUCKING
WARNING: If saw becomes pinched or hung in a log, don’t try to force it out. You can lose control of the saw resulting in injury and/or damage to the saw. Stop the saw, drive a wedge of plastic or wood into the cut until the saw can be removed easily. Restart the saw and carefully reenter the cut. Do not attempt to restart your saw when it is pinched or hung in a log.
Turn saw OFF and use a plastic or wooden wedge to force cut open.
Overcutting begins on the top side of the log with the saw against the log. When overcut- ting use light downward pressure.
Overcutting Undercutting
Undercutting involves cutting on the under- side of the log with top of saw against the log. When undercutting use light upward pres- sure. Hold saw firmly and maintain control. The saw will tend to push back toward you.
WARNING: Never turn saw upside
down to undercut. The saw cannot be con- trolled in this position.
First cut on pressure side of log
Second cut
Second cut
First cut on pressure side of log
BUCKING WITHOUT A
SUPPORT
SOvercut through 1/3 of the diameter of the log.
SRoll the log over and finish with a second overcut.
SGive special attention to logs under strain to prevent the saw from pinching. Make the first cut on the pressure side to relieve the stress on the log.
BUCKING USING A LOG OR SUP- PORT STAND
SRemember your first cut is always on the
pressure side of the log.
S Your first cut should extend 1/3 of the diameter of the log.
S Finish with your second cut. | |
Using a log for support | 2nd Cut |
1st Cut
1st Cut
2nd Cut
Using a support stand 2nd Cut
1st Cut
1st Cut
2nd Cut
11
