TROUBLESHOOTING TABLE
WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.
TROUBLE | CAUSE | REMEDY | |
Engine will not | 1. | Ignition switch off. | 1. Move ignition switch to ON. |
start or will run | 2. | Engine flooded. | 2. See “Difficult Starting” in |
only a few |
|
| Operation Section. |
seconds after | 3. | Fuel tank empty. | 3. Fill tank with correct fuel mixture. |
starting. | 4. | Spark plug not firing. | 4. Install new spark plug. |
| 5. | Fuel not reaching | 5. Check for dirty fuel filter; replace. |
|
| carburetor. | Check for kinked or split fuel line; |
|
|
| repair or replace. |
Engine will | 1. | Idle speed requires | 1. See “Carburetor Adjustment” in the |
not idle |
| adjustment. | Service and Adjustments Section. |
properly. | 2. Carburetor requires | 2. Contact an authorized service dealer. | |
|
| adjustment. |
|
Engine will not | 1. Air filter dirty. | 1. Clean or replace air filter. | |
accelerate, | 2. Spark plug fouled. | 2. Clean or replace plug and regap. | |
lacks power, | 3. Chain brake engaged. | 3. Disengage chain brake. | |
or dies under | 4. Carburetor requires | 4. Contact an authorized service dealer. | |
a load. | adjustment. |
| |
Engine | 1. Too much oil mixed with | 1. Empty fuel tank and refill with | |
smokes | gasoline. | correct fuel mixture. | |
excessively. |
|
|
|
Chain moves | 1. Idle speed requires | 1. See “Carburetor Adjustment” in the | |
at idle speed. | adjustment. | Service and Adjustments Section. | |
| 2. Clutch requires repair. | 2. Contact an authorized service dealer. |
DECLARATION OF CONFORMITY
EC Declaration of Conformity (Only applies to Europe)
We, Husqvarna AB,
COUNCIL’S DIRECTIVES:
of 22 June 1998 “relating to machinery” 98/37/EC, annex IIA;
of 15 December 2004 “relating to electromagnetic compatibility” 2004/108/EC, and applicable supplements; and
of 8 May 2000 “relating to the noise emissions in the environment” in accordance with Annex V of 2000/14/EC. The measured sound power is 108,7 dB(A), the guaranteed sound power is 113 dB(A) and the net power is 1,5 kW.
The following standards have been applied: ISO
EN/ISO 12100-2:2003, and CISPR 12:2001.
Notified body, 0404 the Swedish Machinery Testing Institute, Fyrisborgsgatan 3
The supplied Chain Saw conforms with the sample that underwent the EC type approval.
Ronnie E. Goldman, Director of Engineering
Handheld Consumer Products
16