McIntosh M85 How to Connect How to Connect

How to Connect

McIntosh Control Center

1. Connect a data cable from the TUNER 1 DATA IN jack

to the TUNER DATA PORT of a McIntosh Control

Center or preamplifier.

2. Connect a power control cable from the POWER CON-

TROL IN jack to the POWER CONTROL OUT or

ACC jack of a McIntosh Preamplifier, Control Center

or other McIntosh component.

3. Connect shielded cables from the TUNER 1 FIXED

OUTPUTS to the TUNER INPUTS of a preamplifier

or control center.

Note: An optional connection would be to use the TUNER 1

VARIABLE OUTPUTS.

4. Connect the FM Antenna or Cable (from the Cable

Company) to the MR85 Tuner 75W (Ohm) FM

ANTenna connector.

5. Connect with the supplied cable, from the 5 Pin Socket

of the McIntosh RAA1 Remote AM Antenna to the

MR85 Tuner AM ANT DIN socket.

6. Plug the MR85 AC Power Cord into a live AC Outlet.

To AC Outlet

Contents

Main Table of Contents Please Take A Moment Technical Assistance Customer Service Thank You IMPORTANT SAFETY INSTRUCTIONS! PLEASE READ THEM BEFORE OPERATING THIS EQUIPMENT. Safety Instructions WARNING SHOCK HAZARD - DO NOT OPEN. AVIS RISQUE DE CHOC - NE PAS OUVRIR. Page Performance Features Introduction and Performance Features Introduction Page Installation MR85 Rear Panel and RAA1 Top Panel Connections How to Connect How to Connect How to Connect with Optional Tuner Module How to Connect with Optional Tuner Module Front Panel Controls, Displays, Push-Buttons and Switch Page How to Operate How to Assign Preset Stations How To Clear an Assigned Station Preset How to Assign Preset Stations and Custom Names How to Assign Custom Names Page Information about the Optional TM1 Tuner Module Benefits of Adding the Second McIntosh AM/FM TM1 Tuner Module Specifications FM Tuner Specifications AM Tuner Specifications General Specifications Packing Instructions