Installation
Installation
The MC1.2KW can be placed upright on a table or shelf, standing on its four feet. It also can be custom installed in a piece of furniture or cabinet of your choice. The four feet may be removed from the bottom of the MC1.2KW when it is custom installed as outlined below. The four feet together with the mounting screws should be retained for possible future use if
the MC1.2KW is removed
from the custom installa- tion and used free standing.
The required panel cutout, ventilation cutout and unit dimensions are shown.
Always provide ad- equate ventilation for your MC1.2KW. Cool operation ensures the longest pos- sible operating life for any electronic instrument. Do not install the MC1.2KW directly above a heat gen- erating component such as a high powered amplifier. If all the components are installed in a single cabinet, a quiet running ventilation fan can be a definite asset in maintaining all the system components at the coolest possible operating tempera- ture.
A custom cabinet instal- lation should provide the following minimum spacing dimensions for cool opera- tion.
Allow at least 6 inches (15.24cm) above the top, 2 inches (5.08cm) below the bottom and 1 inch (2.54cm) on each side of the Power
Amplifier, so that airflow is not obstructed. Allow 19- 1/2 inches (49.53cm) depth
behind the front panel. Al- low
out a ventilation hole in the mounting shelf according to the dimensions in the drawing.
1When the MC1.2KW is installed together with other McIntosh Components, check clearances on all components before proceeding.
44.62cm
10
6"
15.24cm Cutout Opening for Custom Mounting
Chassis
Spacers
Cutout Opening for Ventilation
1" 2.54cm
|
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
| 36.83cm |
|
|
|
| |
|
|
|
| |||
|
| 14" | ||||
Cutout Opening | 38.91cm | |||||
35.56cm | ||||||
|
|
for Ventilation
6