Rear Panel Connections and Switch
Circuit Breaker, press to reset if the amplifier will not power up
BALANCED INPUT1 / OUT- PUT for an audio cable from a Preamplifier output or to connect an audio cable onto the next Power Amplifier input
BALANCED INPUT for an audio cable from a Preamplifier or A/V Control Cen- ter audio output
Connect the MC1.2KW power cord to a live AC outlet. Refer to the rear panel to determine the correct voltage
INPUT MODE switch selects between balanced or unbalanced input
POWER CONTROL IN receives turn On/Off sig- nal from a McIntosh com- ponent and the POWER CONTROL OUT sends a turn On/Off signal to the next McIntosh Compo- nent
UNBALANCED INPUT for an audio cable from a Preamplifier or A/V Con- trol Center audio output
OUTPUT Connections | OUTPUT Connections | OUTPUT Connections |
for 2 ohm Loudspeaker | for 4 ohm Loudspeaker | for 8 ohm Loudspeaker |
Caution: The Loudspeaker 
Negative Connections are above chassis ground. Do not combine any connections to- gether, ground them or connect with another MC1.2KW.
1 | This Balanced connector may be used as an | Input ONLY |
|
| |
| when connected to a McIntosh C1000 Preamplifier. For | |
| all other connections use only as an Output. |
|
7
